WASHINGTON, D.C. — The Federal Aviation Administration (FAA) has paused the installation of additional Juniper telecommunications routers after a network disruption triggered a nationwide ground stop across the United States last week, raising fresh questions about the reliability of the country’s air traffic control infrastructure. The agency said it has also disabled the same functionality on more than 60 Juniper routers already operating in its network as a precaution while it investigates the incident. The FAA’s November 15 update and Reuters’ November 17 report detail the agency’s response.
The disruption occurred on Friday, November 13, when the FAA experienced instability in its telecommunications network and issued a nationwide ground stop at approximately 3:30 p.m. Eastern Time. Flights began resuming at about 8:15 p.m. The agency said the instability affected communications and radar feeds at 17 of the country’s 22 Air Route Traffic Control Centers, forcing aviation authorities to take precautionary action while the problem was isolated. According to the FAA, approximately 3,500 aircraft landed safely during the disruption.
Initial findings point to a newly installed Juniper router at a radio communications site in El Dorado, Arkansas, where contractor L3Harris was carrying out work connected to the transition of the FAA’s communications network from older copper lines to fibre-optic infrastructure. The FAA said excessive data flooded its legacy network at a rate of about 1,000 connection attempts every four to five seconds, creating instability in aircraft communications and radar feeds. Investigators are also examining a radar site in Amarillo, Texas. The agency’s technical account says the initial response included blocking the affected locations and disabling the broadcasting function on the new routers.
However, officials have not yet established the definitive root cause. Investigators are examining whether the incident resulted from a hardware defect, an installation or configuration error, or the way the new equipment interacted with older network components. L3Harris is cooperating with the investigation, while testing is being conducted on the equipment. The FAA has said it has no indication that the disruption was caused by a cyberattack. CNN’s report and the FAA’s statement outline the ongoing inquiries.
The pause follows pressure from Democratic members of the Senate Commerce, Science and Transportation Committee, led by Senator Maria Cantwell. In a November 17 letter to Transportation Secretary Sean Duffy and FAA Administrator Bryan Bedford, the lawmakers called for an immediate suspension of further deployments until the cause of the failure is understood and additional safety checks are completed. They said information supplied by L3Harris indicated that 400 of 3,648 planned Juniper router conversions had been installed, with 69 devices operational at the time of their letter. The Senate committee’s letter requested improved operational testing, independent validation, verified failover capability and rollback procedures before installations resume.
The lawmakers also questioned whether existing backup systems were sufficiently resilient to prevent a problem at one communications site from affecting air traffic operations across multiple regions. They asked the FAA and the Department of Transportation to provide a detailed account of the failure and explain how the agency will strengthen oversight of contractors involved in modernising the National Airspace System. The committee said deployment should only resume after the safety and reliability of the equipment have been demonstrated.
The incident has intensified debate over the modernisation of an air traffic control network that still relies on ageing infrastructure. The FAA says the November 13 disruption was linked to instability involving its legacy telecommunications system during routine replacement work, while the precise interaction between the new routers and older equipment remains under investigation. The agency has said it will reassess the timing of maintenance and replacement work following the incident. The FAA’s official update provides further details on the review.
Photo: Air traffic controllers working at the Washington Air Route Traffic Control Center. Photo: Federal Aviation Administration, public domain via Wikimedia Commons.