The Federal Aviation Administration (FAA) has suspended the installation of new Juniper telecommunications routers across its air traffic control network following a technical failure that triggered a rare nationwide ground stop in the United States last Friday. The agency has also disabled the relevant functionality on Juniper routers already installed while investigators work to establish exactly what caused the disruption. The decision was confirmed by an FAA spokesperson to ABC News on Tuesday, November 17, as scrutiny of the country’s aviation communications infrastructure intensified.

How The Arkansas Router Installation Triggered A Nationwide Disruption
The disruption began on Friday, November 13, during routine telecommunications work at an FAA radio communications facility in El Dorado, Arkansas. A new Juniper router had been installed as part of work to replace ageing copper telecommunications lines with fibre-optic connections. When the equipment was brought online, the network experienced an abnormal surge in data and connection attempts, placing significant pressure on older equipment that remained in service. The FAA’s explanation, reported by the Associated Press via MPR News, said the excessive traffic destabilised aircraft communications and radar feeds.

According to the FAA, the system was receiving approximately 1,000 connection attempts every four to five seconds. The volume of traffic overwhelmed older network equipment and produced instability across a significant part of the national air traffic control communications system. The failure was not limited to the Arkansas installation: problems were reported at 17 of the FAA’s 22 regional en route air traffic control centres, which coordinate aircraft travelling at cruising altitudes across the country. Details of the reported network impact were outlined in the November 17 Associated Press report.
The FAA issued the nationwide ground stop on Friday afternoon, temporarily preventing departures across the United States while officials worked to stabilise the system. The restriction was lifted at approximately 8:15 p.m. Eastern Time, after the network recovered sufficiently for normal flight operations to resume. Aircraft already airborne were able to continue to their destinations, while the disruption left passengers at airports facing delays, cancellations and uncertainty. ABC News’ account of Transportation Secretary Sean Duffy’s explanation said officials isolated the affected router communications as part of the response.

FAA Turns Off Installed Routers As Investigation Continues
The FAA’s latest decision goes beyond stopping additional installations. The agency has also disabled the relevant broadcasting functionality on Juniper routers already deployed in the network as a precaution. Transportation Secretary Sean Duffy previously said that 69 of the devices had been installed in the national airspace system and that their ability to broadcast the problematic data had been switched off. The FAA is now relying on older Cisco routers, some of which have been in service for approximately 25 years, while the investigation proceeds. The measures were detailed in the Associated Press report published November 17.
The routers at the centre of the investigation are being examined with the involvement of L3Harris, the government contractor responsible for maintaining the FAA’s telecommunications network. Investigators are seeking to determine whether the incident resulted from a hardware defect, an installation mistake, a configuration problem or an interaction between the new equipment and the older systems. The FAA has not announced a definitive root cause. L3Harris has said it is supporting the investigation, while the router manufacturer’s parent company, Hewlett Packard Enterprise, has disputed the suggestion that the device itself malfunctioned, saying its understanding is that the equipment operated according to the configuration provided by the installer. AeroTime’s technical report outlines the competing explanations.

Senate Democrats Demand Answers And Stronger Safety Checks
The FAA’s move came as Democratic members of the Senate Commerce Committee called for a pause in the wider router replacement programme and demanded a detailed explanation of the failure. The lawmakers questioned whether the new equipment had undergone sufficient testing before deployment and why existing backup arrangements did not prevent the disruption from spreading across so many air traffic control centres. They also argued that identifying the device associated with the incident was not enough; investigators must establish the underlying cause and explain how a similar event will be prevented. ABC News reported on the senators’ letter and their request for briefings.
The lawmakers said the contractor’s planned programme involved 3,648 Juniper routers, with approximately 400 installed and 69 operational at the time of the latest reports. They called for additional operational testing, independent validation, verified failover capabilities and rollback procedures before the deployment resumes. Their position reflects a broader concern that modernisation work on critical aviation infrastructure must not introduce new vulnerabilities into systems responsible for keeping aircraft safely separated and communicating with pilots. CNN’s November 17 report also detailed the senators’ concerns about the scale and pace of the rollout.

Aging Infrastructure Complicates The Modernisation Drive
The incident has renewed attention on the age and complexity of the United States’ air traffic control infrastructure. The FAA has been working to replace outdated telecommunications components and move from copper-based connections to fibre-optic technology. However, the transition requires new equipment to work reliably alongside legacy systems that cannot simply be switched off overnight. The fact that older Cisco routers remain essential to keeping the network operating illustrates the challenge facing the agency as it attempts to modernise a system on which millions of travellers and the aviation industry depend. The Associated Press report describes the older equipment still supporting the network.
The Trump administration has also used the disruption to renew its call for substantial investment in air traffic control modernisation. On Tuesday, the Department of Transportation submitted a funding request of approximately $50.1 billion for improvements that include digital infrastructure, airport facilities, new air traffic control centres and upgrades to control towers. The request is in addition to funding already approved by Congress. The proposal has prompted questions from lawmakers about how the money would be allocated, what safeguards would be introduced and how the government would ensure that previous modernisation challenges are not repeated. ABC News’ coverage of the Senate response and funding request provides further details.
Although officials have said they have no indication that a cyberattack caused the incident, the investigation remains important for determining whether the failure was linked to equipment, software configuration, installation procedures or weaknesses in the network’s design. The distinction matters because each possibility would require a different corrective response. A hardware replacement alone, for example, would not necessarily resolve a configuration or network-management problem. ABC News’ earlier interview with Duffy reported that officials had not established the root cause and were examining the equipment.
What Happens Next?
For now, the immediate priority is to maintain reliable communications between air traffic controllers and aircraft while the affected equipment is examined. The FAA will need to establish what happened in Arkansas, determine why the network experienced such widespread instability and demonstrate that replacement equipment can operate safely with legacy systems before installations restart. The Senate’s demands for independent testing and clear contingency procedures are likely to remain central to the debate over the next phase of the programme. The FAA’s installation pause was confirmed in ABC News’ November 17 report.
The episode is a reminder that modernising aviation technology involves more than purchasing faster or newer equipment. Air traffic control networks depend on several connected systems working together under demanding conditions, and a failure in one part can have consequences far beyond the location where the problem begins. For passengers, airlines and aviation authorities, the key test will be whether the investigation produces practical safeguards that prevent a similar nationwide disruption in the future. The Associated Press’ latest reporting on the FAA’s response provides continuing context for the investigation.
HeadlinesXtra will continue to follow the FAA investigation, the review of Juniper routers and any decisions on when the telecommunications upgrade programme can safely resume.
Photograph credits: Federal Aviation Administration; Harrison Keely / Wikimedia Commons; Derrick Coetzee / NERSC. Contextual and illustrative images are identified in their captions.